Thank you for your purchase of our DIY LASH EXTENSION KIT AND PRODUCTS!
How To Apply DIY LASH EXTENSIONS
To get the best experience, scroll down to see our step by step videos and detailed instructions. Pay extra attention to hand placement. You'll be a lash pro in no time!
Your satisfaction is important to us!
If you require assistance or have questions about the products, please email us and we will respond within 24 hours.
The video instructions below apply to putting the lashes on the right eye using the right hand. If you are left handed, follow these instructions but begin with your left eye first.
How To Apply DIY LASH EXTENSIONS
Watch this video with sound but don't forget to check out the tips below!
BEFORE YOU START
Begin with clean lashes
Clean your lashes with an oil free cleanser
MIRROR PLACEMENT
Use a mirror where you can lay it flat or underneath your face for easy placement
How to Hold Tweezers
Thumb on top, index+middle fingers on the bottom
Last two fingers are to stabilize your hand on your face
How to Hold Lash Pieces
The base of the tweezer should always be flat (180 degrees).
Position the lash cluster to match the slope of the outer and inner lash line. The middle lashes should be held at 90 degrees.
Pick out Lash Pieces
Use clean fingers to gently pull out the 4-5 lash pieces you will use
Do not use tweezers as this will damage the lashes
lubricate tweezer
Brush a tiny bit of REMOVER on the inside tips of the tweezer, then close the tweezer and run along each side. If any BOND gets on the tweezers wipe in between and re-apply if neccessary.
LET THE FUN BEGIN!
APPLY BOND TO YOUR LASHES
Remove excess bond from brush.
Shimmy from the bottom, swipe upwards
Remove any beading from the tips of lashes
PREPARE THE LASH CLUSTERS
Brush a tiny amount of bond on top of the lash band. Put the cluster aside, allowing the bond to become tacky.
Repeat this step for the remaining lash clusters.
Attach outer lash cluster
Steady your hands by placing your ring finger and pinky on your cheekbone
Take your time to line up the lash cluster before you to put it on your natural lash.
Make sure you do not let it touch the wet line! This will cause irritation. When applied correctly, you will not feel the lashes.
PUTTING ON MIDDLE LASHES
For the next 2-3 lashes, hold lash cluster at 90 degrees with tweezer
Stabilize pinky and ring finger on cheekbone. Slowly line up to lash line (do not touch wet area!), then attach to your lashes
Inner Corner Lash - Right Side
Angle the lash cluster upwards towards your hand matching the curvature of your inner lash line.
Stabilize your hand by putting the base of your thumb on your forehead.
Slowly line up the lash to your lash line and attach.
Tip: Do not attach too close to the corner. This will be irritating.
The inner corner is the most difficult to put on, take your time.
LUBRICATE OUTER TWEEZER EDGEES
Apply a tiny amount of Remover on the outer edge of your tweezer to prevent sticking before pressing lashes.
Press Lashes Together
Clean any residue from your tweezer. Apply Untacky.
Sandwich the lashes together and press firmly. Slowly release the tweezer.
Seal Lashes
Brush seal to the bottom 1/3 of your lashes getting it in between the lashes. This step eliminates any tackiness and waterproofs your lashes.
Careful not to touch the tips, otherwise they won't be fluffy. If this happens, put a tiny bit of Remover on the tips and wipe away.
